No.

(Hex.)

Name

Description

Default

(Range)

L8-35

(04EC)

Installation Method Selection

Sets the type of drive installation.

Determined by the drive

(0 - 3)
Note:

  • Parameter A1-03 [Initialize Parameters] does not initialize this parameter.

  • This parameter is set to the correct value when the drive is shipped. Side-by-Side installation

    • Change the value only in these conditions:

    • When you install a UL Type 1 kit on an IP20/UL Open Type drive to convert the drive to an IP20/UL Type 1 drive.

0
IP00/IP20/UL Open Type/Ex Heatsink

Use this setting to install IP00/IP20/UL Open Type drives or when the heatsink (cooling fin) is outside the enclosure panel.

Make sure that there is 30 mm (1.18 in) minimum of space between drives or between the drive and side of the enclosure panel.

1
Side-by-Side Mounting

Use this setting to install more than one drive side-by-side.

Make sure that there is 2 mm (0.08 in) minimum of space between drives.

2
IP20/UL Type 1

Use this setting to install IP20/UL Type 1 drives.

3
Finless

Use this setting to install a finless drive.