|
A
|
ALM/ERR
|
Illuminated
|
The drive detects a fault.
|
|
Flashing 1
|
The drive detects:
Note:
The LED will illuminate to identify a fault if the drive detects a fault and an alarm at the same time.
|
|
OFF
|
There are no drive faults or alarms.
|
|
B
|
Ready
|
Illuminated
|
The drive is operating or is prepared for operation.
|
|
Flashing 1
|
The drive is in STo [Safe Torque OFF] condition.
|
|
Flashing Quickly 1
|
The voltage of the main circuit power supply dropped, and only the external 24 V power supply provides the power to the drive.
|
|
OFF
|
-
The drive detects a fault.
-
There is no fault and the drive received a Run command, but the drive cannot operate. For example, in Programming Mode or when ![[RUN LED]](https://www.yaskawaindia.in/yaskawa_new_admin/uploads/ckuploads/0001038263.svg) is flashing.
|
|
C
|
RUN
|
Illuminated
|
The drive is in regular operation.
|
|
Flashing 1
|
-
The drive is decelerating to stop.
-
The drive received a Run command with a frequency reference of 0 Hz, but the drive is not set for zero speed control.
-
The drive received a DC Injection Braking command.
|
|
Flashing Quickly 1
|
-
The drive received a Run command from the MFDI terminals and is switching to REMOTE Mode while the drive is in LOCAL Mode.
-
The drive received a Run command from the MFDI terminals when the drive is not in Drive Mode.
-
The drive received a Fast Stop command.
-
The safety function shuts off the drive output.
-
The user pushed ![[STOP key]](https://www.yaskawaindia.in/yaskawa_new_admin/uploads/ckuploads/0001038295.svg) on the keypad while the drive is operating in REMOTE Mode.
-
The drive is energized with an active Run command and b1-17 = 0 [Run Command at Power Up = Disregard Existing RUN Command].
-
The drive is set to coast-to-stop with timer (b1-03 = 3 [Stopping Method Selection = Coast to Stop with Timer]), and the Run command is disabled then enabled during the Run wait time.
|
|
OFF
|
The motor is stopped.
|