This procedure makes sure that the parameter setting values that you backed up in the keypad agree with the parameter setting values in the drive.

Note:

  • Always stop the drive before you start to verify the parameters.

  • While you restore parameters, the drive will not accept Run commands.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.

    • If the screen does not show [Home] for [F2 Key], push [F1 Key] (Back), and then push [F2 Key] to show [Home].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [Parameter Backup/Restore], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select the item to verify, then push [ENTER Key].
  5. Push [Up arrow key] or [Down arrow key] to select [Verify (drive → keypad)], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select the data to verify, then push [ENTER Key].

The keypad shows “End” when the parameter settings backed up in the keypad agree with the parameter settings copied to the drive.

Note:

The keypad shows vFyE [Parameters do not Match] when the parameter settings backed up in the keypad do not agree with the parameter settings copied to the drive. Push one of the keys to return to the screen in Step 6.