This example shows how to change the setting value for C1-01 [Acceleration Time 1]. Do the steps in this procedure to set parameters for the application.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.

    • If [Home] is not shown above the [F2 Key], push [F1 Key] (Back).

  2. Push [F2 Key] (Menu).
  3. Push [Up Arrow Key] or [Down Arrow Key] to select [Parameters], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [C Tuning], then push [ENTER Key].
  5. Push [Up arrow key] or [Down arrow key] to select [C1 Accel & Decel Time], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select C1-01, then push [ENTER Key].
  7. Push [LEFT Key] or [RIGHT Key] to select the specified digit, then push [Up arrow key] or [Down arrow key] to select the correct number.

    • Push [F2 Key] (Default) to set the parameter to factory default.

    • Push [F3 Key] (Min/Max) to show the minimum value or the maximum value on the display.

  8. Push [ENTER Key] to keep the changes.
  9. Continue to change parameters, then push [F1 Key] (Back), [F2 Key] (Home) to go back to the home screen after you change all the applicable parameters.