|
End4
|
Adjusted Slip Calculation Error
|
The Auto-Tuning results were not in the applicable parameter setting range.
|
-
Make sure the input motor nameplate data is correct.
-
Do Rotational Auto-Tuning again and correctly set the motor nameplate data.
-
If you cannot uncouple the motor and load, do Stationary Auto-Tuning 2.
|
|
The motor rated slip that was measured after Stationary Auto-Tuning was 0.2 Hz or lower.
|
|
The motor rated slip that was measured after compensation with E2-08 [Motor Saturation Coefficient 2] is not in the applicable range.
|
|
The secondary resistor measurement results were not in the applicable range.
|