Jump to main content

Automatic Parameter Settings Optimized for Specific Applications (Application Presets)

The drive has application presets to set the necessary parameters for different applications to their best values. Use A1-06 from [User Custom Parameters] on the Main menu to check the parameters that were automatically changed by the application preset function.

Note:

Make sure that you set A1-03 = 2220, 3330 [Initialize Parameters = 2-Wire Initialization, 3-Wire Initialization] to initialize parameters before you set A1-06.

This section shows the procedure to set an application preset.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • The keypad will show [Home] in the top right corner when the HOME screen is active.

    • If [Home] is not shown on [F2 Key], push [F1 Key] (Back) to show [Home] on [F2 Key].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [Parameters], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [A Initialization Parameters], then push [ENTER Key].
  5. Push [Up arrow key] or [Down arrow key] to select [A1 Initialization], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select A1-06, then push [ENTER Key].
  7. Push [Up arrow key] or [Down arrow key] to change the value, then push [ENTER Key].

The parameter setting procedure is complete.

Note:

  • For hoist applications, make sure that you do Auto-Tuning after you set A1-06.

  • You cannot change the value set in A1-06. To select an application preset, first set A1-03 = 2220 to initialize parameters and then make a selection to A1-06. If initializing all parameters will cause a problem, it is not necessary to change settings.

  • When the drive changes to the A1-06 setting, it will also reset the parameters automatically registered to A2-17 to A2-32 [User Parameters 17 to 32] when A2-33 = 1 [User Parameter Auto Selection = Enabled: Auto Save Recent Parms].