The data log function saves drive status information. Monitors Ux-xx are the source of log information. The procedure in this section shows how to start logging data.

There are two types of data log functions:

  • Long-term data log: Saves data continuously over an extended time period. You can record a maximum of 10 monitors.

  • Short-term data log: Saves data over a set length of time before and after the drive detects a trigger event with a short sampling cycle. You can record a maximum of 4 monitors.

  1. Make sure that a microSD card is inserted in the keypad.
  2. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.

    • If the screen does not show [Home] for [F2 Key], push [F1 Key] (Back) and then push [F2 Key] to show [Home].

  3. Push [F2 Key] (Menu).
  4. Push [Up arrow key] or [Down arrow key] to select [Diagnostic Tools], then push [ENTER Key].
  5. Push [Up arrow key] or [Down arrow key] to select [Data Logger], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select [Yes] or [No], then push [ENTER Key].

    • [Yes]: Data logging starts.

    • [No]: Data logging will not start.

    If the drive was logging data when you entered the command, the keypad look like this:

    • Long-term data log:

      • Start time of the data log

      • Elapsed time of the data log

    • Short-term data log:

      • Data log start time or trigger detection time

      • Trigger detection count and the log processing status (Sampling or Recording)