1. Use the dimensions in Figure 1 and Table 1 to cut an opening in the control panel for the keypad.
    Figure 1. External/Face Mount Enclosure Panel Cut-Out Dimensions
    Table 1. Panel Cut-Out Dimensions mm (in)

    W

    H

    W1

    H1

    H2

    H3

    d

    22

    (0.89)

    78

    (3.07)

    22

    (0.89)

    29

    (1.14)

    22

    (0.89)

    1

    (0.04)

    3.6

    (0.14)
  2. Remove the keypad and put the keypad connector in the holder on the front cover.
    Note:

    Insert the end of the keypad connector that has the tab.

    Figure 2. Remove the Keypad
    • Keypad
    • Keypad connector
    • Holder
  3. Put the keypad on the outside of the control panel.

    Use M3 screws (6 mm (0.2 in) depth cross-recessed pan head screws) to attach the keypad from the inside. Tighten the screws to a correct tightening torque:

    • M3 screws: 0.49 N∙m to 0.73 N∙m (4.34 lbf∙in to 6.46 lbf∙in)

    Figure 3. Mount to the Outside of Control Panel
    • Keypad
    • M3 screws
    • Enclosure panel
    • Screw mounting holes
  4. Use the extension cable to connect the drive to the keypad.
    Figure 4. Connecting the Drive and Keypad with the Extension Cable
    • Extension cable
    • Communications connector
    • Drive
    • Keypad
    • Cable connector