Installation support sets A or B (sold separately) are necessary for Internal/Flush-Mount installation. To order optional accessories, contact Yaskawa or your nearest sales representative. Note: The installation procedure and panel cut-out dimensions are the same for mounting brackets A and B. Use a gasket between the control panel and the keypad in environments with a large quantity of dust or other unwanted airborne material. Use the dimensions in Figure 1 and Table 1 to cut an opening in the control panel for the keypad. Figure 1. Panel Cut-Out Dimensions to Attach Inside Control Panel Table 1. Panel Cut-Out Dimensions mm (in) W H W1 H1 d 64 + 0.5 (2.52 + 0.02) 130 (5.12) 45 (1.77) 105 + 0.5 (4.13 + 0.02) 4.8 (0.12) Remove the keypad and put the keypad connector in the holder on the front cover. Note: Insert the end of the keypad connector that has the tab. Figure 2. Remove the Keypad Keypad Keypad connector Holder Use the screws included with the mounting bracket, and attach the keypad to the mounting bracket. Use the screws included with the installation support set to attach it. Tighten the screws to a correct tightening torque: M3 screws: 0.49 N∙m to 0.73 N∙m (4.34 lbf∙in to 6.46 lbf∙in) Figure 3. Attach Keypad to Mounting Bracket Keypad Mounting bracket A M3 screws Screw mounting holes Put the mounting bracket that has the attached keypad in the control panel, and use the screws to attach it from the outside. Use the screws included with the installation support set to attach it. Tighten the screws to a correct tightening torque: M4 screws: 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in) Figure 4. Mount Mounting Bracket to the Interior of the Control Panel M4 screws Enclosure panel Use the extension cable to connect the drive to the keypad. Figure 5. Connecting the Drive and Keypad with the Extension Cable Extension cable Communications connector Drive Keypad Cable connector