Wire the drive and other peripheral devices then reattach the terminal cover.
Note:

  • Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.

  • Make sure that you do not pinch wires or signal lines between the wiring cover and the drive before you reattach the cover.

  • Tighten the screws to a correct tightening torque:

    • Models 2257 to 2415: 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)

    • Models 4208 to 4675: 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)

    • Models 4810 to 4H12: 1.96 N∙m to 2.53 N∙m (17.35 lbf∙in to 22.39 lbf∙in)

Figure 1. Reattach the Terminal Cover