|
No.
(Hex.)
|
Name
|
Description
|
Default
(Range)
|
|
n8-51
(053E)
|
Pull-in Current @ Acceleration
|
    
Sets the pull-in current allowed to flow during acceleration/deceleration as a percentage of the motor rated current.
|
Determined by A1-02
(0 - 200%)
|
Adjust in the following situations.
-
When the motor does not smoothly because of large loads, increase the setting value in 5% increments.
-
If too much current flows during acceleration, decrease the setting value.
Note:
When A1-02 = 8 [Control Method Selection = EZOLV], this parameter will always be in effect for speed ranges less than n7-10 [Pull-in Current Switching Speed].