H5-11: Comm ENTER Command Mode

No. (Hex.)	Name	Description	Default (Range)
H5-11 (043C) RUN	Comm ENTER Command Mode	Sets the function to make the Enter command necessary to change parameters through MEMOBUS/Modbus communications.	1 (0, 1)

No.

(Hex.)

Name

Description

Default

(Range)

H5-11

(043C)

RUN

Comm ENTER Command Mode

Sets the function to make the Enter command necessary to change parameters through MEMOBUS/Modbus communications.

(0, 1)

0
ENTER Command Required: Make all parameter changes then input the Enter command. You must use the Enter command to enable changes to parameters.
1
ENTER Command Not Required: It is not necessary to input the Enter command to change parameters.