|
No.
(Hex.)
|
Name
|
Description
|
Default
(Range)
|
|
L6-04
(04A4)
|
Torque Detection Selection 2
|
        
Sets the speed range that detects overtorque and undertorque and the operation of drives (operation status) after detection.
|
0
(0 - 8)
|
The drive detects overtorque if the motor current or output torque is more than the level set in L6-05 [Torque Detection Level 2] for the length of time set in L6-06 [Torque Detection Time 2]. The drive detects undertorque if the motor current or output torque is less than the level set in L6-05 for the length the time set in L6-06.
- 0
- Disabled
-
The drive will not detect overtorque or undertorque.
- 1
- oL @ Speed Agree - Alarm only
-
The drive detects overtorque when the output frequency aligns with the frequency reference. Detection does not occur during acceleration/deceleration. The drive outputs an oL4 [Overtorque Detection 2] and operation continues.
- 2
- oL @ RUN - Alarm only
-
When the Run command is enabled, the drive constantly detects overtorque. The drive outputs an oL4 and operation continues.
- 3
- oL @ Speed Agree - Fault
-
The drive detects overtorque when the output frequency aligns with the frequency reference. Detection does not occur during acceleration/deceleration. The drive outputs an oL4 [Overtorque Detection 2] and operation stops.
- 4
- oL @ RUN - Fault
-
When the Run command is enabled, the drive constantly detects overtorque. The drive outputs an oL4 and operation stops.
- 5
- UL @ Speed Agree - Alarm only
-
The drive detects undertorque when the output frequency aligns with the frequency reference. Detection does not occur during acceleration/deceleration. The drive outputs a UL4 [Undertorque Detection 2] and operation continues.
- 6
- UL @ RUN - Alarm only
-
When the Run command is enabled, the drive constantly detects undertorque. The drive outputs a UL4 and operation continues.
- 7
- UL @ Speed Agree - Fault
-
The drive detects undertorque when the output frequency aligns with the frequency reference. Detection does not occur during acceleration/deceleration. The drive outputs a UL4 and operation stops.
- 8
- UL @ RUN - Fault
-
When the Run command is enabled, the drive constantly detects undertorque. The drive outputs a UL4 and operation stops