|
No.
(Hex.)
|
Name
|
Description
|
Default
(Range)
|
|
H2-06
(0437)
|
Watt Hour Output Unit Selection
|
        
Sets the unit for the output signal when H2-01 to H2-04 = 39 [MFDO Function Selection = Watt Hour Pulse Output].
|
0
(0 - 4)
|
This output is input to the Watt hour meter or PLC through a 200 ms pulse signal. This parameter sets the kWh unit for each pulse output.
Figure 1. Example MFDO when Configured for Watt Hours
Note:
-
When the power value is a negative value (regenerative state), the drive does not count Watt hours.
-
When the control power supply to the drive is operating, the drive will keep the Watt hours. If a momentary power loss causes the drive to lose control power, the Watt hour count will reset.
- 0
- 0.1 kWh units
-
- 1
- 1 kWh units
-
- 2
- 10 kWh units
-
- 3
- 100 kWh units
-
- 4
- 1000 kWh units
-