o2-01: LO/RE Key Function Selection

No. (Hex.)	Name	Description	Default (Range)
o2-01 (0505)	LO/RE Key Function Selection	Sets the function that lets you use to switch between LOCAL and REMOTE Modes.	1 (0, 1)

No.

(Hex.)

Name

Description

Default

(Range)

o2-01

(0505)

LO/RE Key Function Selection

Sets the function that lets you use [LO/RE] to switch between LOCAL and REMOTE Modes.

(0, 1)

0
Disabled: You cannot use to switch between LOCAL and REMOTE Modes.
1
Enabled: You can use to switch between LOCAL and REMOTE Modes when the drive is stopped. When LOCAL Mode is selected, on the keypad will come on.

Warning

Sudden Movement Hazard

If you change the control source when b1-07 = 1 [LOCAL/REMOTE Run Selection = Accept Existing RUN Command], the drive can start suddenly. Before you change the control source, remove all personnel from the area around the drive, motor, and load.

Sudden starts can cause serious injury or death.

Warning

Sudden Movement Hazard

Fully examine all mechanical and electrical connections before you change o2-01 [LO/RE Key Function Selection] or b1-07 [LOCAL/REMOTE Run Selection].

Sudden starts can cause serious injury or death. If b1-07 = 1 [Accept Existing RUN Command] and there is an active Run command when you switch from LOCAL to REMOTE Mode, the drive can start suddenly.

Table 1. Function Settings with o2-01 and b1-07
Function Selection	LOCAL/REMOTE Run Selection	Switching from LOCAL Mode to REMOTE Mode	Switching from REMOTE Mode to LOCAL Mode
o2-01 = 0 [Disabled]	b1-07 = 0 [Disregard Existing RUN Command]	The drive will not switch modes.	The drive will not switch modes.
o2-01 = 0 [Disabled]	b1-07 = 1 [Accept Existing RUN Command]	The drive will not switch modes.	The drive will not switch modes.
o2-01 = 1 [Enabled]	b1-07 = 0 [Disregard Existing RUN Command]	The drive will not start operating although the Run command is active. When you set Run command to active again, the drive will start to run.	The drive cannot operate because the Run command is not enabled.
o2-01 = 1 [Enabled]	b1-07 = 1 [Accept Existing RUN Command]	When the Run command is active, the drive will start to run immediately when the mode switches from LOCAL to REMOTE.	The drive cannot operate because the Run command is not enabled.