Show the frequency reference screen.

Note:

Push and hold [ESC Key] to return to frequency reference screen from any screen.

Use Verify mode to view all parameters that are not at default settings. This is very useful when you replace a drive. When there are no changes to parameter settings, the display shows [nonE]. This lets you quickly access and re-edit changed parameters. Figure 1 shows the procedure.

Note:

The drive will only display A1-02 [Control Method Selection], A1-xx, A2-01 to A2-32 [User Parameter 1 to User Parameter 32], and E5-01 [PM Motor Code Selection].

Figure 1. Verify and Set the Changed Parameters