Show the frequency reference screen.

Note:

Push and hold [ESC Key] to return to the frequency reference screen from any screen.

Use these steps to save a backup of the drive parameters to the keypad.

Backups of the parameter settings can save time when you set parameters after you replace a drive. When you set up more than one drive, you can copy the parameter settings from a drive that completed a test run to the other drives.

Note:

  • Stop the motor before you back up parameters.

  • While the drive makes a backup, it will not accept Run commands.

  • Set o3-02 = 0 [Copy Allowed Selection = Disabled] to protect the parameters saved in the keypad.

Figure 1. How to Save Backed-up Parameters

Push and hold [ESC Key] to go back to the frequency reference screen.