Indicator LEDs and Drive Status

The drive is operating the motor.

• The drive is decelerating to stop.

• The drive received a Run command with a frequency reference of 0 Hz, but the drive is not set for zero speed control.

• The drive received a DC Injection Braking command.

• The drive received a Run command from the MFDI terminals and is switching to REMOTE Mode while the drive is in LOCAL Mode.

• The drive received a Run command from an external source and the drive is not in Drive Ready (READY) condition.

• The drive received a Fast Stop command.

• The safety function shut off the drive output.

• You pushed on the keypad while the drive is operating in REMOTE Mode.

• The drive is energized with an active Run command and b1-17 = 0 [Run Command at Power Up = Disregard Existing RUN Command].

• When b1-03 = 3 [Stopping Method Selection = Coast to Stop with Timer], the Run command is disabled then enabled during the Run wait time.

• The drive received a DC Injection Braking command.

• The voltage of the main circuit power supply decreased, and the 24 V power supply is supplying power only the the drive.

The motor is stopped.

The drive detects a fault.

The drive detected one of the following:

• An alarm

• An oPE parameter setting error

• A fault or error during Auto-Tuning

There are no drive faults or alarms.

The keypad controls the Run command (LOCAL Mode).

The control circuit terminal or serial transmission device controls the Run command (REMOTE Mode).