Check the items in Table 1 after you energize the drive. The keypad display is different depending on drive status.

Table 1. Display Status after You Energize the Drive

Status

Display

Description

During Usual Operation

Initial Setup Screen

or

HOME Screen

  • The data display area will show the Initial Setup screen or the HOME screen

  • Energize the drive with factory defaults to show the Initial Setup screen. Select [No] from the [Show Initial Setup Screen] settings to show the HOME screen without showing the Initial Setup screen.

When the Drive Detects a Fault

The display is different for different faults. Refer to “Troubleshooting” to remove the cause of the fault. [ALM LED] will illuminate.

Note:

If the screen shows a different screen, do these steps to show the fault content again:

  1. Push [LEFT Key] from the HOME screen.

  2. Push [F2 Key] (Home) from a different screen than the HOME screen.