When you install a JOHB-SMP3, Multi-protocol EtherNet option, the keypad can show information about the option.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • The keypad will [Home] in the top right corner when the HOME screen is active.

    • If [Home] is not shown on [F2 Key], push [F1 Key] (Back) to show [Home] on [F2 Key].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [Diagnostic Tools], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [Comm. Option Information], then push [ENTER Key].

The keypad shows the selected monitor as shown in this example figure.

 

Symbol

Name

Description

A

Station Name

PROFINET protocol shows the station name. All other protocols show “JOHB-SMP3”.

Note:

With PROFINET, the screen shows the station name set on the PLC. If you do not set the station name, the screen shows “No Station Name”.

B

Protocol

Shows the protocol set using the DIP switches on the JOHB-SMP3 option.

C

MAC Address

Shows the main MAC address of the JOHB-SMP3 option. Shows the same content as U4-76 to U4-78.

D

IP Address

Shows the IP (Internet Protocol) address assigned to the JOHB-SMP3 option. Shows the same content as U6-80 to U6-83. If there is no IP address assigned to the JOHB-SMP3 option, this will show "000.000.000.000".

E

Subnet Mask

Shows the subnet mask assigned to the JOHB-SMP3 option. Shows the same content as U6-84 to U6-87. If there is no subnet mask assigned to the JOHB-SMP3 option, this will show "000.000.000.000".

F

Gateway Address

Shows the gateway address assigned to the JOHB-SMP3 option. Shows the same content as U6-88 to U6-91. If there is no gateway address assigned to the JOHB-SMP3 option, this will show "000.000.000.000".