The Setup Wizard lets users follow simple messages on the keypad to set these basic parameters:

  • Frequency Reference Source

  • Input signal level

  • Run command source

  • Duty Rating

  • Motor type

  • Control Method Selection

  • Maximum frequency

  • Input/output settings

Note:

The Setup Wizard function will initialize all parameters before it sets the basic parameters.

  1. Push [F2 Key] [Home] to show the HOME screen.
    Note:

    • The keypad will [Home] in the top right corner when the HOME screen is active.

    • If [Home] is not shown on [F2 Key], push [F1 Key] [Back] to show [Home] on [F2 Key].

  2. Push [F2 Key] [Menu].
  3. Push [Up arrow key] or [Down arrow key] to select [Initial Setup], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [Setup Wizard], then push [ENTER Key].
  5. Push [Up arrow key] or [Down arrow key] to select [Yes], then push [ENTER Key].
    Note:

    This operation will initialize all parameters.

  6. Push [Up arrow key] or [Down arrow key] to select the item to set, then push [ENTER Key].
  7. For the next steps, follow the instructions shown on the keypad until the “Parameter Change Confirmation Screen” is shown.
  8. In the parameter change confirmation screen, push [Up arrow key] or [Down arrow key] to examine the changed parameter, then select [Apply of each parameter] at the bottom of the screen and push [ENTER Key].
    Note:

    To change a parameter again, push [Up arrow key] or [Down arrow key] to select the parameter to change, then push [ENTER Key] to show the parameter setting screen.

  9. Push [Up arrow key] or [Down arrow key] to select [Yes], then push [ENTER Key].

The Setup Wizard procedure is complete.