You can automatically back up parameters to the keypad connected to the drive and write those parameters to a drive from the same drive series as specified by the settings of o3-06 [Auto Parameter Backup Selection] and o3-07 [Auto Parameter Backup Interval].

Note:

  • Set o3-06 = 1 [Auto Parameter Backup Selection = Enabled] in each drive to which you will write the parameters.

  • This operation is not available when the parameters in the keypad and the parameters on the other drives are set to the same values.

  1. Connect the keypad to the drive.
  2. Push [Up arrow key] or [Down arrow key] to select [Yes], then push [ENTER Key].
  3. Push [Up arrow key] or [Down arrow key] to select [Yes], then push [ENTER Key].

The keypad will show the “End” message when the write process is complete.