The User Custom Parameters show the parameters set in A2-01 to A2-32 [User Parameter 1 to User Parameter 32]. This lets users to quickly access and change settings to these parameters.

Note:

The User Custom Parameters always show A1-06 [Application Selection] at the top of the list. The A2-01 to A2-32 settings change when the A1-06 setting changes, which makes it easier to set and reference the necessary parameter settings.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.

    • If [Home] is not shown on [F2 Key], push [F1 Key] (Back) to show [Home] on [F2 Key].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [User Custom Parameters], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to show the parameter to examine.
  5. To re-edit a parameter, push [Up arrow key] or [Down arrow key], select the parameter to edit, then push [ENTER Key].
  6. Push [LEFT Key] or [RIGHT Key] to select the digit, then push [Up arrow key] or [Down arrow key] to change the value.
  7. When you are done changing the value, push [ENTER Key].

The parameter setting procedure is complete.