The procedure in this section shows how to show the frequency reference monitor as a trend plot.

  1. Push [F2 Key] [Home] to show the HOME screen.
    Note:

    • The keypad will show [Home] in the top right corner when the HOME screen is active.

    • If [Home] is not shown on [F2 Key], push [F1 Key] [Back] to show [Home] on [F2 Key].

  2. Push [F2 Key] [Menu].
  3. Push [Up arrow key] or [Down arrow key] to select [Monitors], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [Trend Plot], then push [F3 Key] [Setup].
  5. Push [Up arrow key] or [Down arrow key] to select [Custom Monitor 1], then push [ENTER Key].
  6. Push [ENTER Key].
  7. Push [Up arrow key] or [Down arrow key] to select the monitor number to register, then push [ENTER Key].

    Set the x-xx part of monitor Ux-xx. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.

  8. Push [Up arrow key] or [Down arrow key] to select [Trend Plot 1 Scale Minimum Value], then push [ENTER Key].
  9. Push [LEFT Key] or [RIGHT Key] to select the specified digit, then push [Up arrow key] or [Down arrow key] to select the correct number.

    • Push [F2 Key] [Default] to set the parameters to factory defaults.

    • Push [F3 Key] [Min/Max] to move between the minimum value and maximum value.

  10. Push [ENTER Key] to keep the changes.
  11. Push [Up arrow key] or [Down arrow key] to select [Trend Plot 1 Scale Maximum Value], then push [ENTER Key].
  12. Push [LEFT Key] or [RIGHT Key] to select the specified digit, then push [Up arrow key] or [Down arrow key] to select the correct number.

    • Push [F2 Key] [Default] to set the parameters to factory defaults.

    • Push [F3 Key] [Min/Max] to move between the minimum value and maximum value.

  13. Push [ENTER Key] to keep the changes.
  14. Push [F1 Key] [Back].

    If necessary, use the same procedure to set [Custom Monitor 2].