The procedure in this section shows how to set the sampling time for a trend log. When a trend log is set, it works concurrently with the short-term data log to save the data before the trigger is detected.

Note:

This setting is displayed only when short-term data log is selected for the data log type.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • The keypad will show [Home] in the top right corner when the HOME screen is active.

    • If [Home] is not shown on [F2 Key], push [F1 Key] (Back) to show [Home] on [F2 Key].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [Diagnostic Tools], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [Data Logger], then push [F3 Key] (Setup).
  5. Push [Up arrow key] or [Down arrow key] to sselect [Trend Log Sampling Selection], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select the sampling time for the trend log, then push [ENTER Key].

The procedure to set the sampling time for the trend log is complete.