The procedure in this section shows how to set the monitor for which to log data.

  1. Push [F2 Key] (Home) to show the HOME screen.
    Note:

    • When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.

    • If the screen does not show [Home] for [F2 Key], push [F1 Key] (Back), and then push [F2 Key] to show [Home].

  2. Push [F2 Key] (Menu).
  3. Push [Up arrow key] or [Down arrow key] to select [Diagnostic Tools], then push [ENTER Key].
  4. Push [Up arrow key] or [Down arrow key] to select [Data Logger], then push [F3 Key] (Setup).
  5. Push [Up arrow key] or [Down arrow key] to select [Log Monitor], then push [ENTER Key].
  6. Push [Up arrow key] or [Down arrow key] to select the save-destination monitor parameter, then push [ENTER Key].
  7. Push [Up arrow key] or [Down arrow key] to select the monitor number to be logged, then push [ENTER Key].

The configuration procedure is complete.