|
The Parameter Settings Will Not Change
|
The Parameter Settings Will Not Change
|
|
The Motor Does Not Rotate after You Enter a Run Command
|
The Motor Does Not Rotate after You Enter a Run Command
|
|
The Motor Rotates in the Opposite Direction from the Run Command
|
The Motor Rotates in the Opposite Direction from the Run Command
|
|
The Motor Rotates in Only One Direction
|
The Motor Rotates in Only One Direction
|
|
The Motor Is Too Hot
|
The Motor Is Too Hot
|
|
The Correct Auto-Tuning Mode Is Not Available
|
The Correct Auto-Tuning Mode Is Not Available
|
|
The Motor Stalls during Acceleration or Accel/Decel Time Is Too Long
|
The Motor Stalls during Acceleration or Accel/Decel Time Is Too Long
|
|
The Drive Frequency Reference Is Different than the Controller Frequency Reference Command
|
The Drive Frequency Reference Is Different than the Controller Frequency Reference Command
|
|
PM Motor Speed Is Not Stable
|
The Motor Speed Is Not Stable When Using a PM Motor
|
|
There Is Too Much Motor Oscillation and the Rotation Is Irregular
|
There Is Too Much Motor Oscillation and the Rotation Is Irregular
|
|
Deceleration Takes Longer than Expected when You Enable Dynamic Braking
|
Deceleration Takes Longer Than Expected When Dynamic Braking Is Enabled
|
|
The Load Falls When a Brake Is Applied
|
The Load Falls When a Brake Is Applied
|
|
There Is Audible Noise from the Drive or Motor Cables when You Energize the Drive
|
There Is Audible Noise from the Drive or Motor Cables when You Energize the Drive
|
|
Earth Leakage Circuit Breaker (ELCB) Trips During Run
|
Earth Leakage Circuit Breaker (ELCB) Trips During Run
|
|
Motor Rotation Causes Unexpected Audible Noise from Connected Machinery
|
Motor Rotation Causes Unexpected Audible Noise from Connected Machinery
|
|
Motor Rotation Causes Oscillation or Hunting
|
Motor Rotation Causes Oscillation or Hunting
|
|
PID Output Fault
|
PID Output Fault
|
|
The Starting Torque Is Not Sufficient
|
The Starting Torque Is Not Sufficient
|
|
The Motor Rotates after You Shut Off Drive Output
|
The Motor Rotates after the Drive Output Is Shut Off
|
|
The Output Frequency Is Lower Than the Frequency Reference
|
The Output Frequency Is Lower Than the Frequency Reference
|
|
The Motor Will Not Restart after Power Loss
|
The Motor Will Not Restart after a Loss of Power
|